Overview This guide will take you step-by-step through configuration, activation, and confirmation. STEP 2 Power on your device. STEP 3 Activate your device online. STEP 5 Confirm your success! STEP 4 Wait while your device connects. Add page 5 to Favourites. I do not have a network. I have a network. E SERVICEThe location address you provide during online activation is sent to local emergency responders and must be kept up to date if you move your device.
To update your location address information, visit att. Add page 6 to Favourites. Take a break! You will receive a text message and email once activation is complete.
Visit att. The Power light on the front of the device will come on immediately. Within a few minutes, other lights will flash as a GPS signal is located and software is updated. NOTE:It can take up to 90 minutes to complete activation.
Your device may update and restart during this time. Your device is configured and working properly when: » You receive a text message and an email confirmation. Cell phones may take some time to switch to the MicroCell.
Your cell phone may not immediately switch to your MicroCell when you enter its coverage area. It may take seconds or up to five minutes. Other 3G cell phone owners on your approved user list also use their existing wireless plan minutes unless they purchase the Unlimited MicroCell Calling feature. However, calls initiated on the cell tower do not transfer to the MicroCell. Restarting fixes most problems.
Like many electronic devices, the MicroCell and your 3G cell phone may occasionally need to be rebooted turned off and back on again to reestablish their connection to each other. Add page 7 to Favourites. NO: Go to att. STEP 2: Is your power light flashing red?
STEP 3: Have you waited a full 90 minutes after completing online activation and connecting your MicroCell to your broadband connection? NO: Please wait the full 90 minutes. Do not restart your MicroCell prior to 90 minutes as this will delay your activation time. Once you have moved the device, wait 60 minutes for your GPS light to turn solid green. In rare instances it may take up to 24 hours.
Unplug the power adapter from the wall outlet, wait 10 seconds, then plug it back in. Wait 30 minutes for the 3G light to turn solid green. See the required firewall settings on page 23 or go to att. Turn your cell phone off and then turn it back on.
Go to att. Add page 8 to Favourites. A minimum of two HomePlug AV or equivalent devices are required. Similar devices are also available at local electronic stores. If necessary, upgrade to a higher broadband speed.
If necessary, use a longer Ethernet cable or a Powerline Ethernet adapter as described in the above solution. Add page 9 to Favourites.
Disconnect the existing Ethernet cable between your modem and router from your modem. STEP 2. STEP 3. STEP 4. Wait up to 90 minutes for your 3G light to turn solid green. It may take an additional 30 minutes for the 3G light to turn solid green. NOTE: This connection can only be used if you have both a modem and router.
Add page 10 to Favourites. Your MicroCell may need replacement. There are no restrictions on broadband service providers. Satellite Internet service is not supported. Your MicroCell automatically checks for software updates each time you turn it on. If necessary, the MicroCell downloads updated software and then restarts. Will my MicroCell slow down my network? The MicroCell takes up very little of your bandwidth. Downloading music, videos, or other large files may impact the bandwidth available for your MicroCell and affect voice quality.
How do I You will improve the chances of receiving a GPS signal when you install your MicroCell: » On first floor or above basement level. Take a break!
You will receive a text message and email once NO: Go to att. STEP 2: Is your power light flashing red? Disconnect the existing Ethernet cable between your modem and router from your modem. STEP 2. STEP 3. STEP 4. Wait up to
0コメント